How To Bypass Thermal Switch on Water Heater?

Posted on

How to Bypass Thermal Switch on Water Heater – Thermal switch is the electronic component which has the purpose of stopping the gas burner when the water temperature reaches the maximum level. So, the gas burner will stop working. So, if you are using a water heater with this type of switch, then you don’t need to bother about the water heater temperature, as it is automatically controlled by this thermal switch.

See also  How To Clean A Thermocouple On A Water Heater

But there are a lot of people who don’t understand what this thermal switch is used for and they always use it for a wrong purpose. So, here are some tips that will help you to bypass this switch and use it for your own benefit.

https://www.youtube.com/watch?v=Q-SNgjzldUM[/embedyt1. Turn off the power

If you don’t want to use the water heater, then firstly you need to turn off the power. But if you still want to use the heater, then it is possible that you are using the switch in an incorrect way. If you have turned off the power, then you can still use the heater by following these steps.

See also  How To Turn on Whirlpool Water Heater?

2. Remove the switch

Remove the switch from the water heater and disconnect the wires.

3. Connect the wires to the power source

Connect the wires to the power source and make sure that the current is flowing into the water heater.

4. Turn on the power

Once you are sure that the current is flowing in the water heater, then you can start using it.

See also  How To Replace Thermocouple On Gas Water Heater?

Conclusion

I hope you will like this post and these tips. If you are facing any problem while using the water heater, then you need to contact the service provider and check whether the water heater is damaged.

See also  How to Replace a Thermocouple on a Water Heater

Leave a Reply

Your email address will not be published. Required fields are marked *