DIYers’ Guide to Changing a Dryer Belt: A Step-by-Step Process
How To Change Belt On Dryer
Changing a belt on a dryer is a relatively easy task that anyone with basic DIY skills can accomplish. While the steps may vary slightly depending on the model of dryer, the basic process remains the same.
Step 1: Unplug the Dryer
Before you begin, be sure to unplug your dryer from the wall outlet. This will ensure your safety during the repair process.
Step 2: Remove the Access Panel
Once your dryer is unplugged, you will need to remove the access panel. This is usually located on the back of the dryer. It is held in place with either screws or clips. Be sure to remove all screws or clips before attempting to remove the panel.
Step 3: Inspect the Belt
Once the access panel is removed, you should be able to see the belt that runs from the motor to the drum of the dryer. Inspect the belt for signs of wear or damage. If the belt is worn or frayed, it should be replaced.
Step 4: Remove the Old Belt
To remove the old belt, you will need to disconnect it from the motor. This is usually done by unscrewing a retaining bolt or clip. Once the belt is disconnected, you can pull it out from around the drum of the dryer.
Step 5: Install the New Belt
Once the old belt is removed, you can install the new belt. Start by threading the belt around the drum of the dryer. Then, connect it to the motor. Be sure to snugly tighten the retaining bolt or clip.
Step 6: Test the Dryer
Once the new belt is installed, you can plug your dryer back into the wall outlet and test it. Turn the dryer on and make sure the drum is spinning properly. If the drum is spinning, your repair is complete.
Changing a belt on a dryer is a task that any DIYer can accomplish. While the steps may vary slightly depending on the model of dryer, the basic process remains the same. With the right tools and a bit of patience, you can easily and safely change the belt on your dryer.