In order to start the pilot, you need to make sure that the knob on the gas control valve is fully pushed in. Keep the knob pushed in while clicking the button over and over again. For 90 seconds, hold the knob in and click the igniter button over and over again until the light comes on. New water heaters have air in the gas line.
How To Light Pilot On Whirlpool Water Heater
Do you want to know how to light a pilot on a water heater? Well, if your answer is yes then keep reading this short article. There are many people who don’t know how to light a pilot on a water heater. This is mainly because they don’t have any idea about how the water heater works. But, before I explain how to light a pilot on a water heater, I will briefly discuss what a pilot light is.
What is a pilot light?
A pilot light is a small flame which burns at the bottom of the water heater. It is used to provide heat to the water in the water heater. If there is no pilot light then it means that the water heater isn’t getting hot enough to start boiling water. And this will result in a lot of problems. One of the main problems is that the water in the water heater may not be safe to use. In this case, you should call an experienced plumber and ask him to fix the problem.
How does a water heater work?
A water heater has a heating element which is located at the bottom of the water heater. The heating element is connected to a thermostat. When the temperature of the water in the water heater gets to a certain level, then the thermostat will send a signal to the heating element. This will cause the heating element to ignite and burn a gas or an oil which provides heat to the water in the water heater.
How do you light a pilot on a water heater?
To light a pilot on a water heater all you need is a match or a lighter. Hold the match or lighter near the bottom of the water heater. Once you see the pilot light, blow it out. Now, the water heater is ready to use.
Conclusion
I hope I have explained everything about how to light a pilot on a water heater clearly for you. If you still have any questions then feel free to ask in the comments section below.
Where is the reset button on a whirlpool gas hot water heater?
The reset button is typically located on the front panel of the hot water heater.
How do you reset the pilot light on a water heater?
The most common way to reset the pilot light is to turn the gas valve off, then back on. If that does not work, try turning it off and on again in 5-second intervals.