How To Remove The Agitator From a GE Washer?

Posted on

Agitation is a common cause of noisy washing machines. The agitator is the part of the washing machine that moves the clothes around inside the drum.

It is normally made of plastic or metal and spins around the drum. If the agitator stops spinning, it will no longer agitate the clothes and you will hear a loud noise as the water and detergent mix. You can also hear this noise when the agitator is not turning.

Have you ever used a washing machine? If you have then you must have noticed the agitator inside the washer. This is one of the most important parts of the washing machine which keeps the clothes moving during the wash process. This agitator is used for spinning the clothes. It has a rotating shaft with magnets inside it.

See also  How To Stop a Washing Machine Mid Cycle?

If you want to remove the agitator from a washing machine, then it is very easy. You just need to follow these steps and get a beautiful and new agitator.

YouTube player

How To Remove The Agitator From a GE Washer

Steps:

  • Remove the lid and cover the washer’s drum.
  • Use a screwdriver to loosen the screws of the lid.
  • Now gently lift the lid and remove it.
  • If you have a dishwasher, then there are no screws in the lid. So, it will be easier to remove.
  • After removing the lid, take out the agitator and put it on the kitchen counter.
  • Now, you can clean the agitator by using the brush.
See also  How Do You Fix a Washing Machine That Keeps Draining

Conclusion

This was the easiest way to remove the agitator from a washing machine. If you have any questions then don’t hesitate to ask us. We are always here to help you.

FAQ

How can I remove the agitator from a ge washer?

The first step is to remove the door panel. You may have to remove the panel by prying up on the metal tab on the bottom of the door. Remove the two screws that hold the door panel in place. Then, slide the door panel off.

See also  How to Open a Quarter Washing Machine?

Is it hard to remove the agitator?

A: It is not hard to remove the agitator. The agitator is held in place with one screw. You will need to remove this screw to remove the agitator.

What is the best way to remove the agitator?

There are many ways to remove the agitator. The best way is to use a socket and wrench.

See also  Kenmore Washer Lid Lock Bypass

What are some of the tools I should have when removing the agitator?

You should have a socket and a wrench.

Can I damage the washer if I remove the agitator?

Yes, you can damage the washer by removing the agitator.

How do I replace the washer?

To replace the washer, you will first need to remove the agitator. Then, you will need to remove the washer cover. There is usually a small screw holding the washer cover in place. Slide the cover off and then slide the washer out.

See also  How To Wire a Washing Machine Motor?

How do I install the new washer?

After replacing the washer, you will need to reinstall the agitator. There should be a small tab that holds the agitator in place. Slide this tab back into the washer and tighten it. Then, put the washer cover back on.

Leave a Reply

Your email address will not be published.