Plug in the device or get it back up and running. Then, press the red reset button next to the slot for the wrenchette, which is next to the button. Turn on the faucet and the switch. The machine should work as it should. If it doesn’t work again, do the same thing again.
FAQs
Does a Badger 5 Garbage disposal have a reset button?
Yes, all Badger 5 Garbage disposal units have a reset button. To reset the unit, turn off the power to the unit, unplug it from the wall outlet, and then press and hold the reset button with a paperclip for 10 seconds.
How do you troubleshoot a Badger 5 garbage disposal?
The first thing to do is to turn off the power at the breaker. You can then remove the rubber splash guard and try to manually turn the blades by hand. If that doesn’t work, you can try using a wrench or pliers to turn them.
If none of these solutions work, you may need to replace the motor (or the entire unit).
How do you unjam a garbage disposal?
Unblocking or unjam your disposal is simple, but it is necessary to do so safely. As with a loaded rifle, treat the garbage disposal as though it may go off at any time. Assuming the unit is off, reach inside the disposal with long tongs or pliers. Wiggle these around until you find anything inside and take it out. This protects your fingers and hands.
How do you reset a garbage disposal without a reset button?
The first thing you need to do is make sure the disposal is plugged in and turned on. Next, turn off the power. This should stop any water from coming out of the disposal and make it easier to work with.
Next, remove the unit from where it is installed. From there, locate the reset button which will be located on the bottom of the unit or inside of it somewhere. Pressing this button will allow you to reset the disposal and get it working again.
Where is Badger Disposal reset button?
On the lower rear or bottom of the garbage disposer, there is a red button that serves as a reset. The reset button will pop out if the trash disposal gets stuck and the motor overheats.
Why did my garbage disposal suddenly stop working?
The trash disposal may have stopped working because its built-in circuit breaker tripped due to overloading, so look for the reset button under the disposal and press it. When pressing the reset button, wait around 10 minutes before trying again if the button doesn’t stay depressed.
Why is my garbage disposal just humming?
When your trash disposal makes a humming or buzzing noise, it means that the equipment is receiving electricity, but the blades are not spinning. In other cases, the humming noise is a warning that the motor is blocked or jammed, which prevents it from grinding. Sometimes, even if you haven’t turned the garbage disposal off, it will stop on its own.