
The age of a water heater is usually indicated by the model number. If that is not available, then the date of manufacture can be found on a sticker that is usually located on the inside of the door.
The age of a Whirlpool water heater can be determined by looking at the model number and the serial number located on the bottom of the unit. The model number is usually located on a label attached to the front of the unit. The serial number is located on a label located inside the water heater’s packaging.
Whirlpool was the first manufacturer to use this type of labeling. But most other manufacturers have adopted it as well. You can find both labels by removing the top panel from the water heater. Then, simply read the label that is attached to the bottom of the unit.
It will tell you the model number and the serial number of the water heater. Age can also be determined by calling the manufacturer’s customer service department. They will be able to tell you exactly what model number and serial number you have. And, they will be able to tell you the exact age of your water heater.
How To Tell Age Of Whirlpool Water Heater?
Do you know the age of your water heater? If not, it’s time you find out. Water heaters have a lifespan of 10 to 15 years, and if it is over 10 years old, it’s time to think about getting a new one. Here are some signs that your water heater may need to be replaced:
Leaks
Did you know that a water heater can leak as much as 2 gallons of water per day? Leaks occur for a number of reasons, but mostly they occur because of rust. Over time, the metal inside the water heater becomes saturated with iron deposits. These deposits act like tiny magnets that attract moisture in the air, causing it to drip down into the water tank.
If you have a home with hard water, this will cause the iron deposits to be more concentrated. This makes the problem of leaks worse. The solution is simple: just change your water heater. But before you do that, read this letter: “How To Stop Water Leaks Caused By Rust In Your Water Heater”.
Rust spots on the exterior of the water heater are another common cause of leaks. They occur when the hot-water supply line becomes cracked or damaged due to age. Again, the solution is easy: replace the water heater. But before you do that, read this letter: “How To Stop Water Leaks Caused By Cracks In Your Hot Water Supply Line”.
Odd noises
Water heaters can make some noise as they operate. However, if you hear a constant, annoying sound, it could be a sign that something needs to be repaired. If this is the case, call an authorized dealer immediately. Don’t try to repair it yourself because there is a good chance that you will make it worse. Here are three reasons that noise may be coming from your water heater:
Leaky
If your water heater has a loose fitting lid, let us tell you something: It Is Time To Get A New Water Heater!
Vibration
Some older water heaters vibrate when they are in operation. While this is not necessarily a bad thing, it is something that you should be aware of. If this is the case, you may want to cover the water heater with a blanket or old sheet to muffle the sound. You can do this temporarily until you decide what you are going to do about it. Here are three reasons that vibration may be coming from your water heater:
Incorrect Temperature
Older water heaters have a tendency to get the temperature of the water a little high or low. This is usually not a big deal. However, if you notice that your hot water is too hot or too cold, it is time to get a new water heater!
Burning Hazard
Water heaters can get very hot. But if they become too hot, there is a chance that they will start a fire. And while this is unlikely, it is something that you should be aware of. If you notice that your water heater has an unusually high heat output, even when it is not operating, it is time to get a new water heater!