Diagnosing and Replacing a Faulty Washer Lid Switch: A Step-by-Step Guide
Testing a washer lid switch is an important part of maintaining a washing machines performance. A faulty lid switch can cause a washer to stop running unexpectedly during a cycle, or fail to start. To identify and replace a faulty lid switch, you’ll need to follow the below steps.
Before you start, remember to unplug the power cord from the outlet before touching the washer.
The first step to testing a washer lid switch is to locate it. The lid switch is typically located on the top of the washer, near the lid. It will be connected to the lid by a wire or a rod. Once you have located the lid switch, you will need to remove it. Depending on the model of washer, it may be held in place with screws or a locking mechanism.
Once the lid switch has been removed, examine it for signs of wear or damage. If the switch is visibly broken, it should be replaced. If there is no visible damage, you will need to test the switch for continuity. To do this, you will need a multimeter. Set the multimeter to the highest setting, and touch the two leads to the two terminals on the switch. If the multimeter reads continuity, the switch is working properly. If the multimeter reads no continuity, the switch should be replaced.
Once you have determined that the switch needs to be replaced, purchase a new switch. Make sure to purchase a switch that is compatible with your washer. Once you have the new switch, you can begin the installation process. First, remove the old switch from the washing machine. Disconnect the wires or rod from the old switch, and then remove the mounting screws.
Once the old switch has been removed, you can begin to install the new switch. Make sure to connect the wires or rod to the new switch, and then secure the switch in place with the mounting screws. Once the switch has been installed, plug the power cord back into the outlet.
Finally, test the washer to make sure that the new switch is working properly. Turn the washer on, and ensure that the washer stops when you open the lid. If the washer stops, the new switch has been installed successfully.
Testing a washer lid switch is a relatively simple process. By following these steps, you should be able to identify and replace a faulty lid switch. Remember, always unplug the power cord before touching the washer.